25mm Steering Pin Upgrade Kit

  • Model: MCST-212

 Ask a Question 


Show Room Only
Our new Competition Series Steering Upgrade Kit replaces the stock wimpy 17mm pivots with beefy 25mm Chromoly pins. These days with larger tires and hydro-assist steering systems, we often come across Toyota axles with blown up knuckle bearings or even worse, sheared knuckle pivot pins. The Marlin Crawler solution to this weakness starts with pivot pins that are 47% larger than stock and High-Capacity knuckle bearings that are 54% stronger with an increased contact area. These puppies are nearly the same size as Dana 60 parts!!

Next we replace the stock flimsy lower caps with an incredibly stout solid billet version.

Then we finish it off by replacing the long and exposed stud design with grade 12.9 cap bolts and serrated conical washers made in Germany. The end results is an increase in ground clearance by as much as 3/4", measuring only 1" thick!

25mm Chromoly knuckle pivot pins, made in America
116% larger cross-sectional area than stock
47% larger diameter than stock
54% stronger KOYO High-Capacity knuckle bearings made in Japan
Billet lower cap using grade 12.9 studs increases ground clearance up to 3/4"

This product was added to our catalog on Thursday 12 June, 2014.

Who's Online

There currently are 13 guests online.
Your IP Address is:
Copyright © 2022 Locktup Fabrication